Axxess ASWC Manuel d'installation télécharger pdf (Page 11)

Note: Not every radio will have all the possible SWC commands

on the steering wheel. Aftermarket radios that do not have Bluetooth

will not recognize the PTT (Push To Talk) or “On/Off Hook”

commands; however those buttons can be manually programmed

to do other commands in some cases. Please refer to the radio

owner’s manual or wireless remote for specific commands that the

radio will recognize.

1) Completeconnectionstothevehicleandtotheaftermarketradio,

makesurethe3.5mmconnectorisconnected.

IfthisisthefirsttimetheASWC-1isbeinginstalledinavehicle:

2) Turntheignitionon;theLEDwillstartflashingrapidly.

3) After10secondstheASWC-1willgointotheLEDfeedbackmode.

AftertheseriesofLEDflashestheLEDwillstayinaslowconstant

flashstate.Gotostep4.

--- Or ---

IftheASWC-1hasbeeninavehiclebefore:

2) Pressandholdtheresetbuttondownformorethen10seconds.

3) Afterthe10secondstheLEDwillbeginaslowconstantflash.

4) Atthispointpressandholdthe“VolumeUp”buttononthesteering

wheelfor7secondsuntiltheLEDgoessolidred.Nowreleasethe

“VolumeUp”buttonandtheLEDgoes“Off”.“VolumeUp”hasnow

beenprogrammed.

Section 3: Troubleshooting

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 47 48

Pas de commentaire

Axxess ASWC Manuel d'installation Page 11